0
Owner's of the ADC Clothes Dryer AD-464 gave it a score of 0 out of 5. Here's how the scores stacked up:
91
SECTION XI
PENDANT ASSEMBLY
A. PENDANT ASSEMBLY DESCRIPTION
The pendant assembly is used on both the gas and steam model dryer. Within the pendant assembly there is a
three (3) position selection switch used to tilt the dryer in the load tilted, unload tilted, or level position. When the
load tilted or unload tilted selection is made, the load/unload door will open once the door signal has been received,
and the dryer will tilt. The jog forward/jog reverse push buttons, when depressed individually, will cause the
tumbler (basket) to turn clockwise (CW) for forward and counterclockwise (CCW) for reverse. If both push
buttons are depressed together the jog feature is disabled due to the mechanical interlock with the pendant
assembly. This feature is used as a safety device to prevent both drive motors from being energized in opposite
directions.
The EMERGENCY STOP (E STOP) button is a push-to-stop and twist-to-release switch. When the E STOP
button has been depressed the control power to the dryer is disabled. Voltage is still present at the dryer even
though the EMERGENCY STOP (E STOP) has been depressed.
1.
Pendant Assembly Switch
a. Pendant Assembly Switch Replacement
1) Discontinue electrical service to the dryer.
2) Remove the four (4) screws that secure the pendant body together.
3) Mark and identify the wires that will be removed for proper reinstallation.
4) Remove the wires from the contact block being replaced.
6) Reestablish electrical power to the
dryer.
5) To install new contact block,
reverse Step #4 thru Step #2.
Find Your Products By Category
Please Login
