0
Owner's of the ADC Clothes Dryer AD-464 gave it a score of 0 out of 5. Here's how the scores stacked up:
17
The dryer is equipped with a pneumatically operated heat reclaimer damper, which when opened, will recirculate
approximately fifteen percent (15%) of the dryer’s exhaust air.
The heat reclaimer dampener is closed until ignition of flame has been established. Then, the damper piston is
actuated, opening the damper and recirculating fifteen percent (15%) of the exhaust air back over the gas burner
and into the tumbler. The damper remains open for the rest of the drying cycle. On cool down, the damper
closes, exhausting
ALL of the 13,000 cfm which ensures a fast cool down of the load.
H
EAT
R
ECLAIMER
S
ETTINGS
Z = 1-5/8
Y+Z=X Y %HR Inches Reclaimed
1-1/8" 1/2" 7.46 1-1/4"
2-5/8" 1" 15.67 2-5/8"
3-1/8" 1-1/2" 25.37 4-1/4"
3-5/8" 2" 34.32 5-3/4"
4-1/8" 2-1/2" 43.28 7-1/4"
4-5/8" 3" 50.74 8-1/2"
5-1/8" 3-1/2" 58.95 9-7/8"
FULL OPEN 16-3/4"
4. TIGHTEN TOP HEAT RECLAIMER NUTS DOWN
ONTO THE BOTTOM HEAT RECLAIMER NUTS.
EXAMPLE: IF THE DESIRED PISTON STROKE IS
TWO (2) INCHES (5.1 CM), THAN THE
DISTANCE "X" IN THE ILLUSTRATION
MUST BE TWO (2) INCHES (5.1 CM).
3. ADJUST THE BOTTOM HEAT RECLAIMER NUTS
DOWN TO THEIR DESIRED POSITION WHICH
WILL GIVE THE PROPER PISTON STROKE.
2. LOOSEN HEAT RECLAIMER ADJUSTMENT NUTS
ON ALL FOUR (4) CORNERS OF THE HEAT
RECLAIMER PISTON.
HEAT RECLAIMER ADJUSTMENT
1. REMOVE ELECTRICITY FROM THE UNIT.
NOTE: Gas Dryers must have a "Y"
dimension of 1-3/16".
Find Your Products By Category
Please Login
