0
Owner's of the ADC Clothes Dryer AD-464 gave it a score of 0 out of 5. Here's how the scores stacked up:
71
NOTES: For proper cable (wire rope) routing, starting at the piston;
A. Replace the cable (wire rope) thimble and wire rope clamp to one side of the cable.
B. Secure the cable (wire rope) to the piston mount with the 3/8-16 x 1" bolt, 3/8" fender
washer, 3/8" lock washer, and 3/8-16 hex nut.
C. Feed the cable (wire rope) through the cylinder clevis assembly and around the outer
lower right cable pulley, to the upper right cable pulley, to the inner lower right cable
pulley, to the inner lower left cable pulley, to the outer lower left cable pulley, and to the
cylinder clevis assembly.
D. Feed the cable (wire rope) through the wire rope clamp.
E. Feed the cable (wire rope) thimble through the turnbuckle adjustment rod.
F. Feed the cable (wire rope) around the wire rope thimble.
G. Feed the end of the cable (wire rope) through the wire rope clamp and tighten.
H. Adjust the turnbuckle to the proper cable (wire rope) tension.
8) To install new cable (wire rope), reverse Step #7 thru Step #3. (Refer to previous page [page 70].)
9) Reestablish the air supply to the dryer.
10) Reestablish electrical service to the dryer.
c. Load Door Glass Window Replacement
1) Remove ALL of the old silicone from around the door glass.
6) Carefully trim excess silicone (with a razor blade)
after the cure time.
IMPORTANT: Allow a full 72 hours
for the silicone to cure.
2) Clean glass door opening (with alcohol) to
remove ALL foreign residue.
3) Carefully clean new door glass with alcohol
prior to installation.
4) Apply a bead of silicone (ADC Part No. 170730)
to the outer perimeter of the door glass opening.
5) Carefully insert new door glass within the
door glass opening.
Find Your Products By Category
Please Login
