0
Owner's of the ADC Clothes Dryer AD-464 gave it a score of 0 out of 5. Here's how the scores stacked up:
67
Heat Reclaimer - the dryer is equipped with a pneumatically operated heat reclaimer, which when open, will
recirculate approximately fifteen percent (15%) of the dryers' exhausted air. The heat
reclaimer damper is closed until ignition of flame has been established.
7) Remove the eight (8) 5/16-18 hex nuts as well as the four (4) 5/16" lock washers from the heat
reclaimer adjustment rods.
8) Remove the heat reclaimer adjustment plate.
9) Remove the air lines from the top and bottom of the piston.
10) Remove the 1/4" x 1/4" M.P.T. elbow from the top and bottom of the piston.
11) Remove the C-clip from one side of the heat reclaimer base pin.
12) Remove the heat reclaimer base pin from the heat reclaimer piston.
13) Remove the heat reclaimer piston from the eye bracket.
14) To install new heat reclaimer piston, reverse Step #13 thru Step #3.
15) Reestablish the air supply to the dryer.
16) Reestablish electrical service to the dryer.
b. Heat Reclaimer Adjustment.
1) Discontinue electrical service to the dryer.
2) Loosen the heat reclaimer nuts on
ALL four (4) corners of the heat reclaimer piston.
a. Heat Reclaimer Piston Replacement
1) Discontinue electrical service to
the dryer.
3) Remove the C-clip from one end
of the clevis pin.
4) Remove the set screw from the
clevis rod.
2) Discontinue the air supply to
the dryer.
5) Remove the clevis rod from the piston.
6) Measure the distance between the
adjustment nut and adjustment plate
for correct piston stroke.
Find Your Products By Category
Please Login
