0
Owner's of the ADC Clothes Dryer AD-464 gave it a score of 0 out of 5. Here's how the scores stacked up:
68
H
EAT
R
ECLAIMER
S
ETTINGS
Z = 1-5/8
Y+Z=X Y %HR Inches Reclaimed
1-1/8" 1/2" 7.46 1-1/4"
2-5/8" 1" 15.67 2-5/8"
3-1/8" 1-1/2" 25.37 4-1/4"
3-5/8" 2" 34.32 5-3/4"
4-1/8" 2-1/2" 43.28 7-1/4"
4-5/8" 3" 50.74 8-1/2"
5-1/8" 3-1/2" 58.95 9-7/8"
FULL OPEN 16-3/4"
3) Adjust the bottom heat reclaimer nuts down to their desired positions to obtain the proper piston
stroke.
Example: If the desired piston stroke is 2-inches (5.1 cm), then the distance "X" in the
illustration below must be 2-inches (5.1 cm).
4) Tighten the top heat reclaimer nuts down onto the bottom heat reclaimer nuts.
Intake Air Damper/Cool Down Damper - steam model dryers require the use of both an intake air damper
and a cool down damper. During the heat cycle, the intake air
damper is opened to allow fresh air to be drawn across the steam
coils. On the cool down cycle, the inlet air damper closes and the
cool down damper opens. This draws fresh air into the tumbler
(basket) section exhausting
ALL of the 13,000 cfm (368 cmm)
airflow, which insures a fast cool down of the load. (Refer to the
bottom illustration on page 66.)
a. Intake Air Damper Replacement
1) Discontinue electrical service to the dryer.
2) Discontinue the air supply to the dryer.
3) Remove the character panel on the right hand side of the dryer - the 464 perforated panel - to access
the pneumatic piston of the air intake damper.
4) Remove the two (2) 1/4" poly x 1/4" M.P.T. connectors from the piston.
5) Remove the C-clip from one end of the 1/2" clevis pin.
6) Remove the 7/16-20 clevis rod from the piston.
7) Remove the piston from the piston support.
8) To install new intake air damper piston, reverse Step #8 thru Step #3.
9) Reestablish the air supply to the dryer.
10) Reestablish electrical service to the dryer.
Find Your Products By Category
Please Login
