0
Owner's of the ADC Clothes Dryer AD-464 gave it a score of 0 out of 5. Here's how the scores stacked up:
37
17) Reinstall V-belts and tighten the turnbuckle.
IMPORTANT: DO NOT OVERTIGHTEN TURNBUCKLE.
18) Prior to operating the new gear (speed) reducer, fill with 1.4 liters of SAE 90 gear oil.
19) Mount the pillow block bearing on the mounting pads (using the bolts that were removed).
IMPORTANT: DO NOT OVERTIGHTEN BOLTS.
20) Reverse Step #3 from the Pillow Block Removal instructions on page 35.
IMPORTANT: Remove the wooden blocks that were inserted under the tumbler (basket).
NOTE: Verify correct mounting position of the gear (speed) reducer. Make the necessary corrections
and/or adjustments to the gear reducer for proper mounting. Changing the drain plug, the
breather plug, as well as the turnbuckle mounting pad may be required.
NOTE: Inspect ALL of the work performed, checking for security of parts and proper alignment.
21) Reestablish electrical service to the dryer.
g. Retaining Wheel Replacement
1) Discontinue electrical service to the dryer.
2) Remove the front or the rear loading door side panels secured to the front or the rear of the dryer by
removing the sixteen (16) 5/16-18 x 3/4" tap bolts, along with the 5/16" flat washers and the 5/16" lock
washers.
3) Remove the hardware (i.e., bolt, flat washer, spherical washers, and hex nut) from the wheel mount.
4) Remove the retaining wheel that is to be replaced.
5) Install the new retaining wheel.
Reinstall the flat washer and then
the spherical washer on to the
3/8-16 x 3-1/4" bolt, then insert into
the hole of the retaining wheel. Add
the second spherical washer to the
bolt. Holding the retaining wheel
in position, slide the bolt through
the retaining wheel and out of the
hole on the other side of the mount
assembly. Add a 3/8" lock washer
along with a 3/8-16 hex nut to the
bolt hand tight.
Find Your Products By Category
Please Login
