Cisco Systems Switch Cisco Nexus Switch User Manual

0

Out of 0 Ratings

Owner's of the Cisco Systems Switch Cisco Nexus Switch gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 204
 
Send document comments to nexus7k-docfeedback@cisco.com
C-3
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-18634-01
Appendix C Chassis and Module LEDs
Table C-3 describes the I/O module LEDs.
ACT Flashing
green
The module is transmitting or receiving.
Off The module is not transmitting or receiving.
ACT LOG
FLASH
Green The log flash CompactFlash is being accessed. Do not remove the
Compact Flash until the LED is off.
Off The expansion flash CompactFlash is not being accessed. You can remove
the CompactFlash while this LED is off.
ACT
EXPANSION
FLASH
Green The expansion flash CompactFlash is being accessed. Do not remove the
Compact Flash until the LED is off.
Off The log flash CompactFlash is not being accessed. You can remove the
CompactFlash while this LED is off.
CMP MGMT
ETH
Green The management port is operational.
Amber The management port link has been disabled through the software.
Flashing
amber
The management port link is bad and has been disabled due to a hardware
failure.
Off The module does not detect a signal.
CMP
STATUS
Green All diagnostics pass. The CMP is operational (normal initialization
sequence).
Amber Sufficient power is not available for all modules.
Flashing
amber
The diagnostic test has failed.
or
The CMP is not operational because a fault has occurred during the
initialization sequence.
Red The module has detected a slot ID parity error.
Off The CMP is not receiving power.
LINK Green The module has detected a link.
Off The module has not detected a link.
ACT Flashing
green
The module is transmitting or receiving.
Off The module is not transmitting or receiving.
Table C-2 Supervisor Module LEDs (continued)
LED Status Description
Table C-3 I/O Module LEDs
LED Status Description
ID Blinking
blue
The operator has activated this LED to identify this module in the chassis.
Off This module is not being identified.

   Find Your Products By Category