0
Owner's of the Cisco Systems Switch Cisco Nexus Switch gave it a score of 0 out of 5. Here's how the scores stacked up:
Send document comments to nexus7k-docfeedback@cisco.com
D-5
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-18634-01
Appendix D Repacking the Cisco Nexus 7000 Series Device for Shipment
Repacking the System Components
Step 5 Disconnect each system ground by loosening and removing the two M4 screws that attach the grounding
cable to the chassis, and disconnect the other end of the grounding cable. Place the grounding lug and
screws (not the cable) in the accessories box.
Step 6 Loosen and remove the 6 screws that hold each side of the chassis (12 screws total) to the vertical
mounting rails on the rack or cabinet.
Step 7 Position a mechanical lift in front of the chassis and raise its platform to the bottom of the chassis (or no
more than 0.25 inches (0.6 cm) below the bottom of the chassis), so that you can push the chassis onto
the lift platform.
Step 8 Lay the original shipping pallet flat on the floor. This pallet includes a raised portion that is bolted to the
larger pallet. Make sure that the raised portion is on top.
Caution You need four persons for the following step.
Step 9 Use at least four persons to push the chassis onto the mechanical lift.
Caution Be sure to push the chassis only on its frame. Do not push on any of its modules or use the handles on
any modules. Do not use the handles on the side of the chassis to move or lift the chassis. Those handles
are only for adjusting the position of the chassis in the rack or cabinet.
Step 10 After you securely position the chassis on the mechanical lift, use the mechanical lift to move the chassis
to its pallet.
Step 11 Lower the chassis to the level of the pallet or no more than 0.25 inches (0.6 cm) above the pallet.
Caution You need four persons for the following step.
Step 12 Use at least four persons to push the chassis onto the raised portion of the pallet. Position the chassis so
that it is 4 inches (10.2 cm) away from the side of the common edge of the pallet and its raised portion.
Step 13 Attach two angle brackets to the raised portion of the pallet between the chassis and the pallet edge. Do
not tighten the screws that hold these brackets to the pallet—you will need to adjust their placement after
you place the chassis on the pallet. See
Figure D-2.
Find Your Products By Category
Please Login
