0
Owner's of the ACS Clothes Dryer ACS Clothes Dryer gave it a score of 0 out of 5. Here's how the scores stacked up:
15, 30, & 60 cfm Compact Dryers Chapter 4: Operation 22 of 51
Chapter 4: Operation
4-1 Start-up
1. Turn on (energize) the disconnect switch in your power drop, then turn on the
disconnect switch on the dryer.
2. Turn the system ON/OFF switch to ON to energize the display panel.
The process blower starts.
3. Close the slidegate at the bottom of the drying hopper.
Make sure that the blowers turn in the right direction.
4. Fill the drying hopper with material.
5. If your dryer has a water-cooled aftercooler, make sure that sufficient cooling water
(3gpm at 85°F or lower) flows properly through the coil and that you have bled any
trapped air from the system. Make sure the aftercooler has the proper supply water
temperature.
6. Set the process set point on the temperature controller.
7. After the proper pre-drying time for the initial hopper fill has elapsed, fully open the
drying hopper slide gate.
Note: To allow proper residence time during continuous processing,
maintain the material level in the hopper at the midpoint of the air trap
assembly.
Find Your Products By Category
Please Login
