0
Owner's of the ADC Clothes Dryer Gas Electric Steam gave it a score of 0 out of 5. Here's how the scores stacked up:
23
PL10 - RIGHT COIN SLOT DENOMINATION (rCdE)
This program need only be set when a dual coin acceptor is used. The program setting is determined by the
value of the right coin acceptor slot (higher value).
Program settings are from a minimum of 1 to a maximum of 9999.
When used in conjunction with the Left Coin Slot Denomination program, the Phase 5 microprocessor controller
(computer) automatically calculates the ratios necessary for coin insertion time values.
PL11 - TIME FOR AMOUNT TO START (tFAS)
This program is set for the specific value in TIME that will be vended for the programmed “Amount To Start”
(“AtSt”) the dryer. For example, if 25¢ is required to start the dryer for 10 minutes, the settings would be...
PL11 “Time for Amount To Start” ..........“tFAS” = 10
PL12 “Amount To Start” ......................... “AtSt” = 25
In addition, with the “Time For Amount To Start” (“tFAS”) and the “Amount To Start” (PL12 - “AtSt”)
programmed along with the type of coin acceptor (denominations) on the dryer (i.e. 10¢/25¢), the Phase 5
microprocessor controller (computer) will do
ALL calculations and vend the correct amount of time for any coin
inserted after the initial “Amount To Start” has been inserted - including both accumulative coin program settings.
For example, if a dryer is equipped with a 10¢/25¢ dual coin acceptor and the desired “Amount To Start”
(“AtSt”) is 55¢ for 33 minutes (“tFAS”), with the microprocessor controller (computer) set for accumulative
time 10¢/25¢ dual coin acceptor and the desired “Amount To Start” (“AtSt”) is 55¢ for 33 minutes (“tFAS”),
with the microprocessor controller (computer) set for accumulative time, after initial “Amount To Start” is
inserted (55¢), each additional 10¢ inserted would yield 6 minutes, and each additional 25¢ inserted would yield
15 minutes.
PL12 - AMOUNT TO START (AtSt)
This program sets the “Amount To Start” the dryer and can be programmed from a minimum of 1 to a
maximum of 9999.
PL13 - MINIMUM AMOUNT FOR ADDITIONAL TIME (AFAt)
This program need only be set when the Phase 5 microprocessor controller (computer) is set in the “Accumulative
Coin” (“ACOn”) mode (PL01). The value set for this program is what will have to be inserted for more time
after the “Amount To Start” (“AtSt”) has been inserted.
Example No. 1: “Amount To Start” (“AtSt”) is 50¢ for 30 minutes and an additional 50¢ is required for more
time. In this example PL13 should be set for 50¢.
PL14 - MAXIMUM TIME FOR AUTOMATIC DRY (Adrt)
This program is used only when the Phase 5 microprocessor controller (computer) is set in the Automatic Mode.
This program controls the maximum time the dryer will run even if the Dryness Level program (PL02) has not
been reached.
Find Your Products By Category
Please Login
