0
Owner's of the ADC Clothes Dryer Gas Electric Steam gave it a score of 0 out of 5. Here's how the scores stacked up:
10
SECTION III
OPERATING INSTRUCTIONS
NOTE: Unless otherwise specified at the time of ordering, the Phase 5 coin microprocessor controller
(computer) has been preprogrammed by the factory with the parameters shown on page 52
and
page 53 (for ALL dryer models except AD-26/AD-295 and AD-540/WDA-540) and
page 54 and page 55 (for dryer models AD-26/AD-295 and AD-540/WDA-540 only).
Should program changes be found necessary, please read this Phase 5 Coin User’s Manual
carefully to thoroughly familiarize yourself with the Phase 5 coin microprocessor controller
(computer) programming characteristics.
A. TIMED MODE
1. When turning on power or when no cycle is in progress, the light emitting diode (L.E.D.) display will read
“FILL” and/or “Amount To Start” (“AtSt”).
2. Insert coin(s). Once the correct “Amount To Start” has been inserted, the L.E.D. display will read “PUSH.”
3. Select temperature by pushing “HI TEMP,” “LO TEMP,” or “PERM PRESS.” The dryer will start and the
L.E.D. display will read the temperature cycle selected and the drying time.
4. The dryer will continue through the drying and cooling cycles, showing time counting downward.
NOTE: If the door is opened during a cycle, both the heat and motor will stop. However, the Phase 5
coin microprocessor controller (computer) will continue to count downwards in time.
Continuation of the cycle will resume only after the door has been closed and any one (1) of
the three (3) temperature selection buttons is again depressed.
5. Upon completion of the drying and cooling cycles, the buzzer (tone) will sound, and the L.E.D. display will
read “donE” for 5-seconds, at which time the dryer will shut off.
NOTE: If the Anti-Wrinkle Program is active (“Grd”), the L.E.D. display will remain reading “donE,”
and the Phase 5 coin microprocessor (computer) will proceed through the Anti-Wrinkle
Program until the maximum “Guard On Time” has expired or until the door is opened,
whichever comes first. The L.E.D. display will read “FILL” and/or “Amount To Start”
(“AtSt”).
NOTE: If the Anti-Wrinkle Program is not active (“nGrd”) the L.E.D. display will read “donE” until
the main door is opened, at which time the L.E.D. display will read “FILL” and/or “Amount To
Start.”
Find Your Products By Category
Please Login
