0
Owner's of the Grizzly Saw 50/65 Ton Ironworker gave it a score of 0 out of 5. Here's how the scores stacked up:
-28-
G0646/G0647 50/65 Ton Ironworker
Flat Stock Shearing
The flat stock shearing station is designed to
straight or angle cut flat stock or cut one flange
of angle iron stock. Use the adjustable hold-down
and table guides for safe and accurate cuts.
Stay within the following flat stock shearing capac
-
ities for your machine:
Model G0646
Maximum Thickness w/8" (200mm)
Workpiece Width ...............................
5
⁄8" (15mm)
Maximum Thickness w/12" (300mm)
Workpiece Width ...............................
1
⁄2" (12mm)
Maximum Thickness for Single Flange
Cut w/3" x 3" (80mm x 80mm)
Angle Iron ..........................................
3
⁄8" (10mm)
Model G0647
Maximum Shearing
Thickness w/8" (200mm)
Workpiece Width ...............................
3
⁄4" (20mm)
Maximum Shearing
Thickness w/12" (300mm)
Workpiece Width ...............................
5
⁄8" (15mm)
Maximum Thickness for Single Flange
Cut w/ 3" x 3" (80mm x 80mm)
Angle Iron ..........................................
3
⁄8" (10mm)
flat shearing tips
To avoid tooling or workpiece breakage and
the risk of possible injury to the operator,
never attempt to cut a workpiece that is not
adequately supported and held in place.
Never attempt a cutting operation that is
beyond the capacity of your machine.
NOTICE
To make accurate and safe flat stock cuts,
be sure the table and bottom shearing die
are level and even with each other (refer to
Shearing Table Alignment on Page 49).
The workpiece MUST extend through the hold-
down and through the dies, as shown in Figure 31
,
to avoid sudden unexpected upward movement of
the workpiece during the cutting operation.
Figure 31. Flat stock shearing workpiece
position.
Find Your Products By Category
Please Login
