0
Owner's of the 3Com Gas Grill SMART Mobile Stand for Interactive Displays gave it a score of 0 out of 5. Here's how the scores stacked up:
64 | COMPLETING YOUR INSTALLATION AND CONNECTING OTHER PRODUCTS
TO YOUR SMART MOBILE STAND
99-00962-20 REV C0
Connecting Your SMART Response
(formerly Senteo) Interactive Response
System Receiver
Your SMART Mobile Stand integrates with your SMART Response interactive
response system through a USB A connection. Although receivers don’t require
an unobstructed line-of-sight transmission path—such as infrared devices
require—you can operate your SMART Response receiver over longer distances
if you minimize interference, signal reflections and the number and size of objects
between your receiver and the clickers.
To connect
your receiver
1. Position your SMART Response receiver in an unobtrusive location away
from other wireless products, such as 2.4 GHz routers and cordless telephones.
– For temporary installations, place the receiver inside or on top of your
SMART Mobile Stand’s cabinet.
– For permanent installations, you can secure the receiver to the stand
with two screws (not included).
– Orient the receiver with the long side or edge facing the class, as shown.
IMPORTANT
If you installed a SMART Board for Flat-Panel Displays interactive overlay
on your SMART Mobile Stand:
– Position the outside edge of your receiver no more than 6" (15 cm)
from the speaker panels so that you don’t damage the receiver
when you lower your interactive overlay.
OR
– Insert the included clevis pins as described on page 13 to prevent
your SMART Mobile Stand from reaching its lowest position.
6" (15 cm)
Receiver
Find Your Products By Category
Please Login
